Coverage Analysis Report
The Coverage Analysis report helps you determine test case and execution coverage as it related to requirements and application areas. Below are some helpful tips on navigating the Coverage Analysis report.
Open the left panel, click Coverage to open the Coverage Analysis page.
There are three coverage reports as following:
Test Type: This is to filter out manual vs automation test run data for the below analysis data table.
Analysis Data Table: This table shows the test cases for each requirement along with the testing results and number of defects.
2. You can hover over bars / cells / pie slices to see data
Example: When you over over the cell of Requirements Test Run Coverage, a small popup displayed telling you that the Requirement Video Sections has been covered by 7 test runs and 2 of them failed.
3. Click on Heat Map to Drill-down to Details
Check this articles for things you are able to do on Drilldown page